The usage data of a set of 64 hammer pieces proves that their production capacity is three times that of the original hammer piece. The cost of using a hammer for 2 million tons of feed can save 190000 yuan compared to the cost of using the customer'...
The usage data of a set of 64 hammer pieces proves that their production capacity is three times that of the original hammer piece. The cost of using a hammer for 2 million tons of feed can save 190000 yuan compared to the cost of using the customer's original hammer. At the same time, it saves customers the time to replace hammer blades.
This is the replacement of HMT's hammer blades by the factory on April 11th, and the total production by May 12th is approximately 4500 tons. The above figure shows the hammer state after use. The wear of the hammer blade is minimal.
The crushing machine is 968-3, with 64 hammer pieces and a hammer size of 245 * 62 * 6. The sieve aperture is 2.5mm, and the crushing material is corn.
The hammer blades originally used in the factory were approximately crushed to 6000 tons and replaced. That is 6000/64=93 tons, which is the normal service life of domestic hammer blades. Basically 70-100 tons per piece.
The above picture shows the state of HMT's hammer blades after 3 months and 10 days of use, and the overall hammer blade head is still relatively intact. With a monthly production of 4500 tons and a total production of 15000 tons in 3 months and 10 days, it is not a problem to continue using 18000 tons. Compared to the production capacity of 6000 tons of similar products, the service life of HMT's hammer blades is three times longer.
EN
